Features for solarmode
under review
R
Rico Bamert
I wish that you can set an increased room temperature in the solar mode in addition/instead of the increased target temperature.
Since I only have radiators, the desired target temperature is strongly dependent on the outside temperature, i.e. I have to adjust it again and again. An increase in the target room temperature in 0.5 steps would be more comfortable from my point of view.
A
Artur Rychcik
marked this post as
under review
R
Rico Bamert
Perhaps it would be more effective to switch to the heating curve and raise the setpoint rather than constantly adjusting the constant temperature to match the outside temperature. I’m not sure if that’s possible, though; it might only be possible to do this directly via the control panel.
R
Rico Bamert
Oops, I just realized that this is already possible. You can set both parameters under the “Constant Flow” menu.
Photo Viewer
View photos in a modal
R
Rico Bamert
I’ve just tested it. Unfortunately, it looks as though it doesn’t work as I thought it would. I must have misinterpreted something.
So I still hope that, in solar mode, it will be possible to select a higher room temperature as well as a higher flow temperature.